TITEBOND II FLUORESCENT WOOD GLUE

Features & Benefits

Visible under black light
Enables detection and removal of dried glue before finishing
Passes ANSI Type II water-resistance
Versatile – Bonds wood, hardboard, high pressure laminates and particleboard
Solvent-resistant
Fast set – Shortens clamp time
Ideal for radio frequency (R-F) gluing systems
Easy cleanup with water
Application Guidelines

Application Temperature: Above 55?F
Open Assembly Time: 5 minutes (70?F./50%RH)
Total Assembly Time: 10-15 minutes (70?F./50%RH)
Minimum Required Spread?: Approximately 6 mils or 250 square feet per gallon
Required Clamping Pressure: Enough to bring joints tightly together (generally, 100-150 psi for softwoods, 125-175 psi for medium woods and 175-250 psi for hardwoods)
Method of Application: Easily spread with a roller spreader or brush, or may be transferred to plastic bottles for finer gluing applications.
Cleanup: Damp cloth while glue is wet. Scrape off and sand dried excess.
Note: For best viewing use a black light with a wavelength of 375 ? 400 nm (nanometers).

Bond Strength ASTM D-905 (On Hard Maple)

Temperature
Strength
Wood Failure
Room Temperature
3,750 psi
72%
150?F. Overnight
1,750 psi
6%
Physical Properties

Type: Cross-linking polyvinyl acetate
Calculated VOC: 3.0 g/L
State: Liquid
Weight Per Gallon: 9.1 lbs.
Color: Honey cream
Dried Film: Translucent, yellow
Flashpoint: > 200?F
Solids: 48%
Freeze / Thaw Stability: Stable
Viscosity: 4,000 cps
pH?: 3.0
Chalk Temperature: To assure a good bond, 55?F is the lowest recommended temperature of the glue, air and materials during application.
Storage Life: 24 months in tightly closed containers at 75?F
Limitations

Titebond II Fluorescent Glue is not for continuous submersion or for use below the waterline. Not for structural or load bearing applications. Do not use when temperature, glue or materials are below 55?F. Due to low pH, product may cause corrosion on metal surfaces, test product before using where rusting/corrosion may be of concern. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore product to original form. Because of variances in the surfaces of treated lumber, it is a good idea to test for adhesion. For best results gluing exotic or oily woods, such as Ipe and Teak, please contact our Technical Support Team at 1-800-347-4583. Not FDA approved for indirect food contact. Read MSDS before use. KEEP FROM FREEZING. KEEP OUT OF THE REACH OF CHILDREN.

Important Notice: Our recommendations, if any, for the use of this product are based on tests believed to be reliable. Since the use of this product is beyond the control of the manufacturer, no guarantee or warranty, expressed or implied, is made as to such use or effects incidental to such use, handling or possession or the results to be obtained, whether in accordance with the directions or claimed so to be. The manufacturer expressly disclaims responsibility therefore. Furthermore, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing laws and/or patents covering any material or use.